Unisteer 8010780-02 Chevelle Power Rack & Pinion Kit 19 User Manual download pdf

pg. 1 655680

1964-67 CHEVELLE POWER RACK AND PINION KIT

INSTALLATION INSTRUCTION MANUAL

8010780-01 & 8010780-02

Full refund will NOT be granted to any kits that are

damaged, scratched, or altered in any fashion.

Please note that this installation used Hooker 2-1/8” Super Comp Headers.

*USE ONLY POWER STEERING FLUID IN SYSTEM. DO NOT USE ATF.

*ALTHOUGH THIS KIT IS FAIRLY SIMPLE TO INSTALL SOME

MODIFICATIONS ARE NECESSARY TO INSTALL.

*BEFORE STARTING BE AWARE OF THE MODIFICATIONS NEEDED.

*ALSO BE AWARE THAT THERE ARE APPLICATION/PROVISIONS NEEDED

IN ORDER TO INSTALL. PLEASE READ ALL INSTRUCTIONS FIRST.

*DUE TO VARIABLES OUTSIDE OUR CONTROL THESE KITS MAY NOT FIT

ALL APPLICATIONS. ALSO, PLEASE VERIFY THAT KIT WILL FIT YOUR

APPLICATION BEFORE ALTERING VEHICLE.

1 2 3 4 5 6 7

pg. 1 655680 1964-67 CHEVELLE POWER RACK AND PINION KIT INSTALLATION INSTRUCTION MANUAL 8010780-01 & 8010780-02 Full refund will NOT be grant

pg. 2 655680 Kit Contents: # Part Number Description Quantity 1 8010770-01 Rack & Pinion Assembly 1 1 8060700 Pump Kit 1 2 8021580 Hose Kit w/

pg. 3 655680 6. Remove cotter pins & nuts at outer tie rod ends. 7. Remove two bolts & nuts at passenger side of vehicle attaching idler

pg. 4 655680 11. Remove four bolts retaining stabilizer bar mount bushing & let stabilizer hang free from links. Installation: 1. Your rack

pg. 5 655680 Shaft Installation: 1. Cut the steering column 1” from the bottom support bearing (see pic below). 2. Install column joint end onto

Page 6

pg. 6 655680 7. Slide lower shaft through heim joint & install bracket over the driver side from bolts & mounting bracket. 8. Install u-j

pg. 7 655680 2. Next, route your lines from the remote reservoir to the return side of the pump and then out the pressure side of the pump to the

No comments

Unisteer 8010780-02 Chevelle Power Rack & Pinion Kit 19 User Manual