Page 1 656980 ’65-’66 Impala Rack & Pinion Kit Instructions # 8010280-01 Full refund will NOT be granted to any kits that are damaged, scratc
Page 10 656980 13. You are now ready to install the shaft. Make sure your steering wheel is centered and locked. Your rack and pinion has been ship
Page 11 656980 15. Fill the reservoir with fluid. Start the car and let idle. Turn car immediately off and do not turn steering wheel. Refill reser
Page 2 656980 KIT CONTENTS: # Part Number Description Quantity 1 8012130-01 RACK & PINION UNIT W/BRACKET 1 2 700420 HYDRAULIC SEALANT 1 3 8021
Page 3 656980 Disassembly 1. From under the hood remove the bolts holding the rag joint together so that it will come apart. Remove the outer tie
Page 4 656980 3. Remove the 3 bolts on the driver side frame rail that retains the steering box to the frame. Unscrew the factory steering hoses f
Page 5 656980 5. Next take off the old power steering pump, brackets, and hoses. Then install the new power steering pump kit by using the same tw
Page 6 656980 6. Now install the passenger side mounting bracket into the same place as the original idler arm by sliding it up through the hole i
Page 7 656980 8. You are now ready to install the rack and pinion. Your rack has come assembled to the main mounting bracket. Put the rack and bra
Page 8 656980 9. Next install a jam nut from each of the outer tie rod ends on the end of the rack. After that screw the outer tie rod on each end
Page 9 656980 11. Once your pump and rack are installed you are now ready to install the hoses. Banjo fittings and sealer come with the rack and wi
Comments to this Manuals