Unisteer 8051150 Truck Steering Shaft User Manual download pdf

UNISTEER

Performance Products

Truck Steering Shaft Assembly Instructions

8051100, 8051110, 8051120, 8051130, 8051140 & 8051150

Full refund will NOT be granted to any kits that are

damaged, scratched, or altered in any fashion.

Note: Before doing any modifications inspect your vehicle to assure the

new part fits your application. This includes length, and spline sizes

(column and steering box).

1) Turn your vehicle’s wheels so that they are in the straight-ahead position.

Make sure your steering wheel does not move to insure correct steering

wheel alignment.

2) Remove the factory steering shaft fasteners that secure the unit to the

steering box and steering column. Remove the factory steering shaft from

your vehicle.

3) Measure the distance between the steering column and the steering box.

NOTE: This measurement should be made from the notch in the

steering box shaft to the notch on the steering column shaft

4) Find the centered length of the UNISTEER shaft. Do this by completely

collapsing the shaft, taking a measurement, and then completely

1 2 3 4

UNISTEER Performance Products Truck Steering Shaft Assembly Instructions 8051100, 8051110, 8051120, 8051130, 8051140 & 8051150 Full refund w

Page 2

extending the shaft, taking a measurement and splitting the difference of the two measurements. (Fig. 2, 3 & 4). 5) Install the U-Joint

Page 3

6) When you are sure of the size, the tube side of the shaft must be drilled through one side of the tube. (see fig 7 below). Determine this hole

WWW.UNISTEER.COM 655550 (01/16/07)

No comments

Unisteer 8051150 Truck Steering Shaft User Manual